| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| ignore this double post! http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=9675 |
Page 1 of 1 |
| Author: | nathan c [ Tue Dec 05, 2006 11:20 am ] |
| Post subject: | |
My build is based on a Gibson AJ. I've used the dimensions for the length, lower & upper bout, and waist that I found on the net. The thing is I haven't found the bracing locations for the back. Is there a "standard" ratio used for the location of the braces on the back? If not, how are the brace locations typically calculated? |
|
| Author: | tippie53 [ Tue Dec 05, 2006 9:49 pm ] |
| Post subject: | |
I can't say there is a standard but I use martin's layout from the neck joint point 3 3/4 7 10 3/4 14 1/2 I tried differecnt location , but what I found is the shape is more important than location. good luck john hall |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|